Port 8089 is open, automatic port forward in the Channels DVR page in on and I've set a rule for port forwarding in the router settings.įor reference these are the last few entries in the log:Ĥ 11:01:07.476388 Successfully mapped port 8089 using natpmpĤ 11:01:07.636782 Created database snapshot: backup-20200214.110107Ĥ 11:01:07.637017 Removing old backup backup-20191106.131055Ĥ 11:01:08.165798 Bonjour service registered with Neils-iMac.localĤ 11:01:17.738657 Pruned 79 expired airings from GBR-1001670-DEFAULT in 108.570472ms.Ĥ 11:04:56.334816 Successfully mapped port 8089 using natpmpĪny help would be appreciated as I've given myself a headache. I've tried what feels like 100's of different settings. time period for which to allow a connection before requiring. If you do not see a green dot for the Back to My Mac status, you should check your router manual for how to enable UPnP or NAT-PMP. I have spent the last few hours stuck in a Google hole looking for answers as well as going through every setting on my Apple router to ensure that port forwarding has been properly configured. UPnP would work as well, but NAT-PMP is a better protocol and tailscaled only needs one of them. Please ensure that port 8089 has been properly forwarded from your router to the IP address of the computer you installed Channels DVR Server on. Remote Access is enabled, but we can not reach your server. If by 'Plug and Play protocols' you are referring to both UPnP & NAT-PMP. Your Channels DVR Server at home can not be reached. I am unable to make a local network connection to my new WD EX2 Ultra M圜loud apparently because of a difference in Plug and Play protocols expected by the M圜loud device and those supported by the Apple Time Capsule. Click Port Mapping (If Port Mapping does not appear, you have the Time Capsule set up in Bridge Mode. Everything works perfectly when I'm on wifi but as soon as I try it remotely using the iOS app on my iPhone or iPad on a 4G connection I get the following message: Open AirPort Utility - Click Manual Setup. The main reason for giving this a go is to be able to remotely access recordings and to be able to set recordings when I'm away from home. I then checked the logs and found out that it denies my computers request because it does not belong to the LAN, even though it is. UPnP is correctly configured with no default deny just to make sure. It does not seem to explicitly state that routers on both ends must support UPnP or NAT-PMP. I used the miniupnp client to make sure of that. The Apple knowledge base article on setting up Back To My Mac lists an 'AirPort base station (AirPort Extreme, AirPort Express, or AirPort Time Capsule) or other Internet router that supports UPnP or NAT-PMP' as one of the requirements. Really like what I see and it's a joy to use in macOS. Recently I discovered that UPnP, while enabled, is not actually working. I'm a bit of a noob to this so I'll try and explain as much as I can.ĭownloaded Channels yesterday and activated a trial DVR subscription.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |